SPRAY APPLICATOR SET UP

STEP 1
Unscrew the solution cup and fill ¾ full. Overfilling the solution cup
may cause leaks.

STEP 2
Insert the solution cup and screw tightly.

STEP 3
Set the nozzle by turning, vertical position for up and down and
horizontal position for left and right spraying. The nozzle can also
be turned 360° and adjusted diagonally for technicians who are trained
in contouring.

STEP 4
Adjust the solution dial on the back of the applicator to choose the
amount/flow of solution you would like to dispense. A higher setting
will result in more solution being distributed. Setting your applicator
on 2-4 for the body and 2 for the face is best recommended.

STEP 5
Attach hose- Insert the longer narrow hose fitting into the bottom of
the applicator and turn anticlockwise until firm, ensuring the fitting
lines up with the bottom of the applicator.

SPRAY SYSTEM SET UP

STEP 1
Attach the hose to the unit. Insert hose fitting into the unit and turn clockwise
until firm. This connection is similar to a light bulb connection, 
avoid over tightening as this may result in broken components.

STEP 2
Attach the Power cord and turn the power on at the wall switch.

STEP 3
Turn on your unit by pressing the ON/OFF button and choose your
desired POWER setting by pressing the + or – on the control panel.
The power is controlled via the digital control button located at the
top of the unit and consists of six spray levels. The recommended power
setting is 3 depending on the solution and speed of the application

Note: Your Pro V system is NOT compatible with harsh cleaners such as gun cleaners, chlorine bleach, or 100% ethanol. Using these cleaners will cause damage to the system.